石油英语6.ppt_第1页
石油英语6.ppt_第2页
石油英语6.ppt_第3页
石油英语6.ppt_第4页
石油英语6.ppt_第5页
已阅读5页,还剩31页未读 继续免费阅读

下载本文档

版权说明:本文档由用户提供并上传,收益归属内容提供方,若内容存在侵权,请进行举报或认领

文档简介

1、Petroleum Sience in English,Instructor: Guo Qing,Chapter Six Petroleum Production Production may be considered as that section of the oil industry concerned with conveying(传送) hydrocarbons(烃) from the reservoir(油藏) to surface, and the separation(分离) of oil, gas, water, and solids to the extent neces

2、sary to provide a saleable primary product(初级产品) such as crude oil, NGL(natural gas liquids), and gas.,Producing oil is an intricate(复杂的) art. Oil can be pumped out of the sponge rock(海绵状岩体) at a certain maximum(最大的) rate, determined by the viscosity(粘稠度) of the oil and the quality(质量) of the reserv

3、oir. Oil production must be managed carefully to avoid clogging(堵塞) or collapsing(跨塌) the pores(孔隙), which can prevent a well from accessing(获取) much of the reservoir. Pumping too fast, pumping too slowly or interrupting(间歇式的)production can all damage an oilfield. And not only one but many wells mus

4、t be drilled to fully exploit(开发) the reservoir, raising the expense(费用) of production.,Drilling curved(斜的) and horizontal(水平的) wells into reservoirs is a common technique to increase production. Another technique involves fracturing(压裂) the reservoir rock by pumping fluids and sand into it under hi

5、gh pressure. The fluids open cracks(裂隙), and the sand keeps them open to let out the petroleum. This can overcome low permeability(渗透率). Treating the wellbore(井筒) with various acids(酸) or solvents(溶剂) can also raise permeability. This technique is called acidizing(酸化) .,One of the most commonly uses

6、 methods of fracturing is hydraulic fracturing(水力压裂). Hydraulic fracturing may be defined as the process of creating a facture(裂缝) or fracture system(裂缝系统) in a porous medium(孔隙介质) by injecting a fluid under pressure through a well bore in order to overcome native stresses(天然压力)and to cause material

7、 failure(岩石破裂) of the porous medium(孔隙介质). Briefly it is the creation(形成) and preservation(保持) of a fracture in a reservoir rock(储集岩). To fracture a reservoir rock, energy must be generated by injecting a fluid down a well and into the formation(地层).,Reservoir Production Mechanisms(机理) The productio

8、n mechanisms which owe their existence to these sources of energy are referred to as “water drive”(水驱), “solution gas drive” (or “depletion drive”)(溶解气驱), and “gas cap drive”(气顶驱) respectively. The natural drainage of the oil through the reservoir rock under its own gravity(重力) provides a further pr

9、oduction mechanism. A combination of drive mechanisms may operate in the same reservoir. Generally, however, one system will dominate(占支配地位) the others and the relative importance of these will change with time during the production of oil and for this reason it is convenient to consider each type o

10、f drive mechanism separately and care must be taken during the development of an oil field to use the reservoir drive pressures to their maximum extent(最大程度).,Water drive(水驱): reservoirs drive their energy from water below the oil. Water sweeps the oil up and into the wells. Water drive (edge-water

11、drive) is considered to be the most effective recovery mechanism of all. In order to enable this mechanism to function at its maximum effectiveness(最大程度上发挥作用), it may be necessary to limit(控制) the rate of oil production so that the aquifer water(淡水) can enter the vacated(腾出空隙的) section of the oil-be

12、aring zone as fast as the oil is withdrawn.,If the oil production rate exceeds(超过) this limit there will be a decline(下降) in the reservoir pressure and a consequent reduction(相应地降低) in the energy available to produce the oil.,Solution gas drive(溶解气驱) (dissolved gas drive or depletion drive) is cause

13、d by gas dissolved in the oil. In the subsurface(地下), the oil is under high pressure. The higher the pressure, the more gas that can be dissolved in the oil. When a well is drilled into the oil reservoir, pressure is relieved(缓解) and gas bubbles(气泡) form in the oil.,Expanding gas bubbles(气泡膨胀) force

14、 the oil into the well. Dissolved gas drive is very inefficient, producing only from 10% to 30% of the oil in place(地质储量), leaving the rest in the reservoir.,Gas cap drive(气顶驱) (free gas drive) derives(获取) its energy from the pressure of the gas in the free gas cap. The expanding free gas cap sweeps

15、(扫) the oil into the well. Gas cap drive is relatively efficient, producing 355 to 50% of the oil in place.,This type of reservoir is best developed with wells producing only from the oil portion of the reservoir, leaving the gas in the free gas cap to supply the energy.,gravity(重力) is also a drive

16、mechanism. It is present in all reservoirs, as the weight of the oil column creates pressure causing oil to flow into the well. This is usually insignificant(不太重要)compared to original pressures(原始压力) created by the other drive mechanisms. In the later stages(阶段) of oil production in a dissolved gas

17、drive reservoir, however, gravity drainage(重力驱) becomes significant(重要). This is called a gravity drainage pool(重力驱动油藏).,(Hydrocarbon Recovery Ratio),(Total Produced Hydrocarbon ),(Reserves in Place),100%,=,Recovery ratio(采收率),Production of Oil and Gas,Primary recovery(一次采收率) In primary recovery-the

18、 initial approach to produce oil-natural reservoir pressure(油藏的天然压力)or simple mechanical pumps(简单的机械泵) are used to raise oil to the surface. Until about 20 years ago recovery factors of over 20% during the primary production phase(一次生产阶段) were most exceptional(不常见的). However modern techniques of fie

19、ld development and production have improved these figures considerably and now the average primary recovery(平均一次采收率) is between 20% and 30%. A number of methods can improve primary recovery.,The most common is infill drilling ,which involves drilling more wells into the same pool so the oil does not

20、 have to travel as far through the rock to reach a wellbore. More than one directional well(定向井) can be drilled from a common platform(共同的钻井平台). Horizontal drilling(水平钻井), which extends(使延伸) the wellbore into a much large portion of the oil-bearing formation, has been employed since the late 1980s t

21、o improve production and enhance recovery.,Secondary recovery(二次采收率): Further oil production can be obtained by injecting(注入) water (waterflooding)(水驱) or natural gas to maintain(保持) reservoir pressure and push(推) oil out of the rock, therefore achieve more efficient displacement(驱替) of oil. the dev

22、elopment of secondary recovery schemes(方案) to be an almost standard practice in new fields has almost doubled(使翻倍) the overall recovery percentage.,Tertiary recovery(三次采收率): The third major phase of crude oil recovery which uses more advanced(先进的) methods aiming to(旨在) increase oil recovery ratio. T

23、he most common tertiary recovery method for light and medium crude oil(轻质油和中质油) is miscible flooding(混相驱). In this procedure, natural gas liquids (ethane, propane and butane) are injected into special injections wells(专门的注入井). When dissolved, these liquids reduce(降低) surface tension(表面张力) and viscos

24、ity(粘稠度) to help release(释放) the oil from the reservoir rock. Carbon dioxide(二氧化碳) has also been used for miscible floods. This phase is applied before the well can be abandoned(废弃). More Researches are conducted continuing to improve the recovery ratio.,Some factors that will limit producing rate.

25、1. Low reservoir permeability(油藏渗透率低) 2. Low reservoir pressure for depth (井深油藏压力低) 3. Formation damage(地层破坏) 4. Wellbore or tubing plugging(井筒或油管堵塞) 5. High viscosity oil (高粘稠度油) 6. Excessive back pressure on formation (地层回压过高) 7. Inadequate artificial lift (人工举升不足) 8. Other situation (其他情况),Enhanc

26、ed Oil Recovery(提高采收率) Enhanced oil recovery (EOR) processes have their objective(目标) to increase of oil recovery for reservoirs depleted(衰竭) by secondary recovery with water flooding or gas injection. The EOR processes can be divided into three categories; chemical(化学驱), thermal(热力驱) and miscible(混

27、相驱), which can be further subdivided into various categories. Thermal processes have been used extensively for the displacement of heavy oil(重油驱替), where as chemical and miscible displacement processes have been employed for the recovery of light oil(轻质油开采).,Light oil: thinner, freely flowing crude

28、oil of light specific gravity(特殊比重). Heavy oil: dense, viscous oil, with a high proportion(比例) of bitumen, that is difficult to extract(开采) with conventional (传统的)techniques and is more costly to refine.,API degrees: the American Petroleum Institute(美国石油协会) defines the density(比重) of oil in gravity

29、units called API degrees(API度). The API degrees are expressed in the following formula(公式):,API degrees,=,141.5,-,Special gravity 60/60 F,-,131.5,Where specific gravity 60/60 F (15.5 C) is the gravity of the oil at 60 F compared with that of water at 60 F . Note that API degrees are inversely propor

30、tional(成反比) to density. Thus light oil have API gravities of over 40 (0.83 specific gravity), whereas heavy oils have API gravities of less than 10 (1.0 specific gravity). Heavy oils are thus defined as those oils that are denser than water.,Microbial enhanced oil recovery (微生物提高采收率法) The use of mic

31、ro-organisms(微生物) and their metabolic products(代谢产物) to stimulate oil production is receiving interest worldwide. The technique involves the injection of selected(经过挑选的) micro-organisms into the reservoir.,EOR(提高采收率),Chemical flooding(化学驱),Thermal recovery(热力驱),Miscible flooding(混相驱),Surfactant floo

32、ding(表面活性剂驱),Polymer flooding(聚合物驱),Caustic flooding (碱法驱),In-situ combustion(火烧油层),Steam injection(蒸汽驱),Wet combustion(湿式燃烧),Miscible slug process(混相段塞法),Enriched gas process (富气注入法),High pressure lean gas process(高压贫气注入法),Mutual solvent process(中性溶剂注入法),CO2 process (二氧化碳注入法),Illustration of Steam

33、Flood Process,There are three main types of conventional natural gas wells. Since oil is commonly associated with natural gas deposits(天然气藏), a certain amount of natural gas may be obtained from wells that were drilled primarily for oil production. These are known as oil wells(油井). In some cases, th

34、is “associated” natural gas is used to help in the production of oil, by providing pressure in the formation for the oils extraction(石油开采). The associated natural gas may also exist in large enough quantities to allow its extraction along with the oil. Natural gas wells(天然气井) are wells drilled speci

35、fically for natural gas, and contain little or no oil.,Condensate wells(凝析油井)are wells that contain natural gas, as well as a liquid condensate(凝析油). This condensate is a liquid hydrocarbon mixture that is often separated from the natural gas either at the wellhead, or during the processing of the n

36、atural gas. Depending on the type of well that is being drilled, completion may differ slightly. It is important to remember that natural gas, being lighter than air, will naturally rise to the surface of a well. Because of this, in many natural gas and condensate wells, lifting equipment and well t

37、reatment are not necessary.,Artificial Lift(人工举升) In most oilfields reservoir pressure decline(下降) and increased volumes(体积) of water produced with the oil give rise to(导致) conditions where the wells will not flow unaided(没有帮助). A number of options, such as gas lift(气举), subsurface pumps(潜泵) and rod

38、 pumps(有杆泵), are open to assist oil flow to surface.,A Horse Head Pump for mechanic production well,Key words separation(分离) primary product(初级产品) the sponge(海绵状岩体) viscosity(粘稠度) clogging(堵塞) collapsing(跨塌) Interrupting production (间歇式的生产) exploit(开发) fracturing(压裂) cracks(裂隙) acids(酸) solvents(溶剂) acidizing(酸化) .,hydraulic fracturing(水力压裂) porous med

温馨提示

  • 1. 本站所有资源如无特殊说明,都需要本地电脑安装OFFICE2007和PDF阅读器。图纸软件为CAD,CAXA,PROE,UG,SolidWorks等.压缩文件请下载最新的WinRAR软件解压。
  • 2. 本站的文档不包含任何第三方提供的附件图纸等,如果需要附件,请联系上传者。文件的所有权益归上传用户所有。
  • 3. 本站RAR压缩包中若带图纸,网页内容里面会有图纸预览,若没有图纸预览就没有图纸。
  • 4. 未经权益所有人同意不得将文件中的内容挪作商业或盈利用途。
  • 5. 人人文库网仅提供信息存储空间,仅对用户上传内容的表现方式做保护处理,对用户上传分享的文档内容本身不做任何修改或编辑,并不能对任何下载内容负责。
  • 6. 下载文件中如有侵权或不适当内容,请与我们联系,我们立即纠正。
  • 7. 本站不保证下载资源的准确性、安全性和完整性, 同时也不承担用户因使用这些下载资源对自己和他人造成任何形式的伤害或损失。

评论

0/150

提交评论