Influence_of_injection_molding_parameters_on_the_e.pdf

ofof008ofofon10,8822,6280ofintoto to of to of 2830, 31, 32,33. In 0 kg C/a on a By of it to +49 3514658395; +49 P. Poat to NT a of 001000 4 be NT in to or 510 1114 1519, NT as in It is NT at 2023be to 24. So a of as a 25,26NT as a of to be in NT be 4,27, on in of of by of up to of up to of in a a of a in at 007 A. A. B. E. 13 a In to or of 007; in - 211 2007 , 01069 007; 5 0072008) 777789 I(2 a 5 at a 95 00 a 0 kg/to in a in a 20 at h 7 X 2 X 5 on to 0 80 2of a 8 (2008) 777789to is it of to of on C/is in to If to in In of a to an of to a of 34,35. to be by to NT As in on 36, on of in In to a of a of be a to a in of C/in To be in EM a a 5 in of C a 0 10 a .2 g/15 a nm 05 0 . et 37by a A to an of it an mm/s, a 0 a 00 8 3 mm 1) I 6 on of on of . 6 ) an of 5%. of 1. of as by a I, 5 6 , + - to +2+ 4+0 +6+ 0+0 +10 011 12 014 06 et , as as of to in of in C a 0 an 0 mm/s, a 0 a 00 of to a of of z1(z2(mm/s) 176C) 176C) +) 80 150 100 32040 10 60 280I +) 70 150 100 32035 10 60 280of of 6 6 an in an mm an 0 , 1041013X)an 04X of a 000 , 1006X)in a an .9 mm an 1 ). 2 of in a FL to so of an 04X by of a in ,1007X). of mm in of of by of of in at in 3)on a 055 at A a 5 (by of M 912 (8 (2008) 777789 779on of 50 nm a 80 T. et ). A a 5a 15to of 2 2 15 in to to of an in to to In an of 3. in 2. of in of be to of 8 (2008) 777789in of on of (2 of a wt% 4. at by of to C is in 014X cm , of , 7, 13, 5 in 07X cm , of of of to to 1 (1)(4). of q. (5)yi( 1 1 1 1 1 1 1 1 1 01 01 01 01 01 11101 01 01 01 01 1 1 1 1 011 011 01 01 011101 1 1 01 01 1 1 01111101 011 0 0110 01 1 0111011101101 008)7777892j16i1j=6)(8), 2 1 1 1 1 12 11111113 1 014 1110151101161 0 171 01 011181101 091 0 01112 1 01 0111 0 011 0 0