网络设备配置与管理项目总结

1、一：实训目的和要求通过课程所学内容对网络设备配置，以完成实训内容，达到要求的效果二：实训任务pc2、pc3、pc4能相互访问；pc4能访问pci；pc2、pc3不能访问pci；pci可以访问pc2的web服务；配置NAT使之处于私网内的pc2、pc3、pc4可以访问外网路由器之间ppp协议用CHAP验证三：拓扑图四：设备六：最终目标1.PC1可以访问PC2web服务2.PC2，PC3, PC4 相通3.PC4能访问PC1，PC2、PC3不能访问PC七：实训步骤（1）交换机SWA的配置reset saved-configurationsystem-viewsysname SWAvlan 100Q

2、uitInterface eth 1/0/1 port link-type access port access vlan 100 interface eth 1/0/2 port link-type access port access vlan 100 Quit vlan 10interface eth 1/0/22 port link-type trunk port trunk permit vlan 10 100 interface eth 1/0/24 port link-type trunkport trunk permit vlan 10 100 quit（2）交换机SWB的配置

3、reset saved-configurationsystem-viewsysname SWBvlan 10port eth 0/1quitvlan 100quitinterface eth 0/22port link-type trunkport trunk permit vlan 10 100quit（二）路由器的配置1.路由器R1的配置reset saved-configuration system-viewinterface s 0/0ip address quitRipNetwork Quit(1)单臂路由的相关配置interface eth 0/0.10vlan-type dot1

4、q vid 10ip address interface eth 0/0.20vlan-type dot1q vid 100ip address quit(2) Easy IP配置方法acl number 2000rule 0 deny permit source 55Quitinterface s 0/0nat outbound 2000quit(3)配置 NAT serverinterface s 0/0nat server protocol tcp global 0 www inside www quit(4) PPP的chap验证配置过程(路由器R1设为主验证方)Local-user

5、R1Password simple helloService-type pppQuitInterface s 0/0Link-protocol pppPpp chap user R1Undo shutdownQuitReset saved-configurationSystem-viewInterface s 0/0Ip address Interface e 0/0Ip address Quitrip路由的配置RipNetwork Network QuitPPP协议的chap验证配置 Local-user R1Password simple hello Service-type ppp QuitInterface s 0/0Link-protoco