版权说明:本文档由用户提供并上传,收益归属内容提供方,若内容存在侵权,请进行举报或认领
文档简介
1、土木工程专业外文翻译-高层建筑 外文原文tall buildings although there have been many advancements in building construction technology in general, spectacular achievements have been made in the design and construction of ultrahigh-rise buildings. the early development of high-rise buildings began with structural steel f
2、raming. reinforced concrete and stressed-skin tube systems have since been economically and competitively used in a number of structures for both residential and commercial purposes. the high-rise buildings ranging from 50 to 110 stories that are being built all over the united states are the result
3、 of innovations and development of new structural systems. greater height entails increased column and beam sizes to make buildings more rigid so that under wind load they will not sway beyond an acceptable limitexcessive lateral sway may cause serious recurring damage to partitions, ceilings, and o
4、ther architectural details. in addition, excessive sway may cause discomfort to the occupants of the building because of their perception of such motion. structural systems of reinforced concrete, as well as steel, take full advantage of the inherent potential stiffness of the total building and the
5、refore do not require additional stiffening to limit the sway in a steel structure, for example, the economy can be defined in terms of the total average quantity of steel per square foot of floor area of the building. curve a in fig. 1 represents the average unit weight of a conventional frame with
6、 increasing numbers of stories. curve b represents the average steel weight if the frame is protected from all lateral loads. the gap between the upper boundary and the lower boundary represents the premium for height for the traditional column-and-beam frame; structural engineers have developed str
7、uctural systems with a view to eliminating this premium systems in steeltall buildings in steel developed as a result of several types of structural innovations. the innovations have been applied to the construction of both office and apartment buildings frames with rigid belt trusses. in order to t
8、ie the exterior columns of a frame structure to the interior vertical trusses, a system of rigid belt trusses at mid-height and at the top of the building may be used. a good example of this system is the first wisconsin bank building 1974 in milwaukee framed tube. the imum efficiency of the total s
9、tructure of a tall building, for both strength and stiffness, to resist wind load can be achieved only if all column elements can be connected to each other in such a way that the entire building acts as a hollow tube or rigid box in projecting out of the ground. this particular structural system wa
10、s probably used for the first time in the 43-story reinforced concrete dewitt chestnut apartment building in chicago. the most significant use of this system is in the twin structural steel towers of the 110-story world trade center building in new york column-diagonal truss tube. the exterior colum
11、ns of a building can be spaced reasonably far apart and yet be made to work together as a tube by connecting them with. diagonal members intersecting at the center line of the columns and beams. this simple yet extremely efficient system was used for the first time on the john hancock center in chic
12、ago, using as much steel as is normally needed for a traditional story buildingfig. 1. graphical relationship between design quantities of steel and building heights for a typical building framecurves a and b correspond to the boundary conditions indicated in the two building diagrams. 1 psf 0. 048k
13、pabundled tube. with the continuing need for larger and taller buildings, the framed tube or the column-diagonal truss tube may be used in a bundled form to create larger tube envelopes while maintaining high efficiency. the i10-story sears roebuck headquarters building in chicago has nine tubes, bu
14、ndled at tile base of the building in three rows. some of these individual tubes terminate at different heights of the building, demonstrating the unlimited architectural possibilities of this latest structural concept. the sears tower, at a height of 1450 ft 442 m, is the worlds tallest buildingstr
15、essed-skin tube system. the tube structural system was developed for improving the resistance to lateral forces wind or earthquake and the control of drift lateral building movement in high-rise building. the stressed-skin tube takes the tube system a step further. the development of the stressed-sk
16、in tube utilizes the facade of the building as a structural element which acts with the framed tube, thus providing an efficient way of resisting lateral loads in high-rise buildings, and resulting in cost-effective column-free interior space with a high ratio of net to gross floor areabecause of th
17、e contribution of the stressed-skin facade, the framed members of the tube require less mass, and are thus lighter and less expensive. all the typical columns and spandrel beams are standard rolled shapes, minimizing the use and cost of special built-up members. the depth requirement for the perimet
18、er spandrel beams is also reduced, and the need for upset beams above floors, which would encroach on valuable space, is minimized. the structural system has been used on the 54-story one mellon bank center in pittsburgh systems in concrete. while tall buildings constructed of steel had an early sta
19、rt, development of tall buildings of reinforced concrete progressed at a fast enough rate to provide a competitive challenge to structural steel systems for both office and apartment buildings framed tube. as discussed above, the first framed tube concept for tall buildings was used for the 43-story
20、 dewitt chestnut apartment building. in this building, exterior columns were spaced at 5.5-ft 1.68-m centers, and interior columns were used as needed to support the 8-in.-thick 20-cm flat-plate concrete slabs tube in tube. another system in reinforced concrete for office buildings combines the trad
21、itional shear wall construction with an exterior framed tube. the system consists of an outer framed tube of very closely spaced columns and an interior rigid shear wall tube enclosing the central service area. the system fig.2, known as the tube-in-tube system, made it possible to design the worlds
22、 present tallest 714 ft or 218m lightweight concrete building in houstonfor structure of only 35 s oriel building the unit 52?story one shell plaza of a traditional shear wall systems compiling both concrete and steel have also been developed,an example of which is the composite system developed by
23、skidmore,owings & merrill in which an exterior closely spaced framed tube in concrete envelops an interior steel framing,thereby combining the advantages of both reinforced concrete and structuralsteel systems.the 52?story one shell square building in new orleans is based on this system.new words an
24、d phrases1.spectacular 壮观的,惊人的,引人注意的2.sway 摇动,摇摆,歪,使倾斜3.residential 居住的,住宅的,作住家用的4mercial 商业的,商业上的,商务的5.innovation 革新,创新,新方法,新事物6.boundary 分界线,边界7.eliminate 排除,消除,除去8.apartment 公寓住宅,单元住宅9.column 柱,支柱,圆柱,柱状物10.demonstrate 示范,证明,演示,11.project 凸出,投射,计划,工程12.stress 应力,压力13.truss 构架,桁架14.bundle 捆,束,包15.t
25、erminate 使终止,使结尾,结束16.facade 房屋的/e面,立面,表面17.perimeter 周,周围,周界,周长18.encroach 侵犯,侵占,蚕食19.high?rise building 高层建筑20.reinforced concrete 钢筋混凝土21.spandrel beam 窗下墙的墙托梁22.shear wall 剪力墙中文译文高层建筑 大体上建筑施工工艺学方面已经有许多进步, 在超高层的设计和施工上已经取得了惊人的成就。 高层建筑早期的发展开始于钢结构。钢筋混凝土和薄壳筒系统已经经济而竞争性地被用于大量的住宅和商业目的的结构。由于新型结构系统的创新和发展,
26、现在从50到100层的高层建筑遍布全美国。 更大高度的要求增加了梁柱的尺寸以使建筑物刚性更强,以便在风荷载作用下建筑物将不会产生超过一个可接受限度的摆动。过度的侧移可能导致隔墙,天花板和其他建筑细部的重复性损害。此外,过度侧倾可能使建筑物的居住者因为对摆动的知觉而导致不便。钢筋混凝土和钢结构系统,能充分利用整个建筑物固有潜在的劲性,因而不需要额外加劲以限制侧倾。 例如,在一个钢结构中,经济性由建筑物房屋面积每平方英尺钢的全部平均数量来定义。图一中的曲线a采用层逐渐增加的数量表现传统框架的平均单位重。曲线b则表现框架受到所有横向荷载保护下的平均钢重量。上下边界之间的间隙则表现传统梁柱框架为高度付
27、出的额外费用。结构工程师已经发展了可消除这一额外费用的结构系统。 钢结构体系。因为一些类型的结构改革,钢高层建筑物得到了发展。此改革被用于办公大楼和公寓的建造。 带有刚性带式桁架的框架。为了将一个框架结构的外柱约束于内部的垂直梁架,可能在建筑物中部和顶部采用一个刚性带式桁架的系统。这一系统的最好例证是在密尔瓦基的威斯康辛州第一银行建筑物 1974。 框架筒体。只有当建筑物突出地面的所有的柱构件能够彼此连接使整个建筑物成为一个空心筒体或一个劲性箱体时,一幢高层建筑的整个结构才能最有效。这种特殊的结构体系第一次大概是用于芝加哥的43层楼高的德威特栗木钢筋混凝土公寓。而这一系统最重要的应用是纽约的110层楼高的世界贸易中心的钢结构双塔。 对角柱桁架支撑筒体。建筑物的外柱可以被适当的分隔却仍能通过在梁柱中线处交叉对角构件连接使之作为一个筒体而共同工作。这种简单而又极其有用的系统最早被用于芝加哥的约翰汉考克中心,其仅仅使用了传统的40层楼高建筑的用钢量 组合筒体(束筒)。由于对更大更高的建
温馨提示
- 1. 本站所有资源如无特殊说明,都需要本地电脑安装OFFICE2007和PDF阅读器。图纸软件为CAD,CAXA,PROE,UG,SolidWorks等.压缩文件请下载最新的WinRAR软件解压。
- 2. 本站的文档不包含任何第三方提供的附件图纸等,如果需要附件,请联系上传者。文件的所有权益归上传用户所有。
- 3. 本站RAR压缩包中若带图纸,网页内容里面会有图纸预览,若没有图纸预览就没有图纸。
- 4. 未经权益所有人同意不得将文件中的内容挪作商业或盈利用途。
- 5. 人人文库网仅提供信息存储空间,仅对用户上传内容的表现方式做保护处理,对用户上传分享的文档内容本身不做任何修改或编辑,并不能对任何下载内容负责。
- 6. 下载文件中如有侵权或不适当内容,请与我们联系,我们立即纠正。
- 7. 本站不保证下载资源的准确性、安全性和完整性, 同时也不承担用户因使用这些下载资源对自己和他人造成任何形式的伤害或损失。
最新文档
- 开放获取科技期刊管理新动向
- 期货公司税务筹划指南
- 电子商务外协产品管理办法
- 家具制造业质量异常管理策略
- 桌球室墙面施工协议
- 别墅装修隔层施工合同
- 军工级元器件选用管理办法
- 广告宣传居间人管理规则
- 电力设施安装简易合同
- 建筑改造安全施工合同范本
- 医院陪检外送人员管理方案
- 部编版《道德与法治》一年级上册教案(全册)
- 2024年纪检监察综合业务知识题库及完整答案(历年真题)
- 教学病例讨论模板
- 基于STM32的智能家居控制系统的设计与开发
- 2024-2029年中国心理咨询行业发展分析及发展趋势预测报告
- 医疗事故的心得体会(18篇)
- 从偏差行为到卓越一生3.0版
- 现实与理想-西方古典绘画 课件-2023-2024学年高中美术人美版(2019)美术鉴赏
- 认识经济全球化 说课课件-2023-2024学年高中政治统编版选择性必修一当代国际政治与经济
- 2024网站渗透测试报告
评论
0/150
提交评论