IEC标准对应表[表格借鉴]

1、62271-203IEC:2003Common numbering of IEC 62271 publications falling under the responsibility of subcommittees SC 17A and SC. 17cIEC 62271 seriesHIGH-VOLTAGE SWITCHGEAR AND CONTROLGER高压开关设备和控制设备Old IEC number if anypartNew title 1Common specifications 通用说明IEC 606942Seismic qualification for rated vol

2、tages of 72.5Kv and above72.5kV及以上设备抗地震性能-100High-voltage alternating current circuit-breakers 高压交流断路器IEC 60056101Synthetic testing 合成测试IEC 60427102High-voltage alternating current disconnections and earthing switches 高压交流隔离开关和接地开关 IEC 60129103Switches for rated voltages above 1kV and less than 52kV

3、1kV52kV的开关设备IEC 60265-1104Switches for rated voltages of 52 kV and above52kV及以上的高压开关设备IEC 60265-2105Alternating current switch-fuse combinations 高压交流开关熔断器组合IEC 60420106Alternating current contactors and contactor-based motor-starters交流接触器和IEC 60470107Alternating current switchgear-fuse combinations高

4、压交流开关设备熔断器组合-108Switchgear having combined function开关设备的联动功能-109Series capacitor by-pass switches串连电容器-200AC metal-enclosed switchgear and control gear for rated voltage above 1kV and up to and including 52 kV1kV52 kV 交流金属封闭开关和控制设备IEC 60298201Insulation-enclosed switchgear and controlgear for rated

5、voltage up to and including 52 kV52 kV及以上绝缘封闭开关设备IEC 60466202High-voltage/ Low-voltage prefabricated substations 高低压箱式变电站IEC 61330203Gas-insulated metal-enclosed switchgear for rated voltages above 52 kV额定电压在52 kV以上气体绝缘金属封闭开关设备 IEC 60517204High-voltage gas-insulated transmission lines for rated volt

6、ages of 72.5 kV and above额定电压在72.5 kV及以上高压气体绝缘输电线路IEC 61640(300)Guide for seismic qualification of high-voltage alternating current circuit-breakers高压交流断路器地震条件导则IEC 61166(301)Guide for inductive load switching感应负载开关导则（高压交流断路器）IEC 61223(302)Guide for short-circuit and switching test procedures for me

7、tal-enclosed and dead tank circuit-breakers金属封闭和落地罐式断路器的短路和开合试验程序导则IEC 61633(303)Use and handling of sulphur hexafluoride (SF6) in high-voltage switchgear and controlgear高压开关和控制设备种SF6的使用和操作IEC 61634(304)Additional requirements for enclosed switchgear and controlgear from 1 kV to 72.5 kV to be used i

8、n severs climatic conditions 1 kV 到 72.5 kV封闭开关和控制设备用在特殊环境条件下的附加要求IEC 60932(305)Cable connections for gas-insulated metal-enclosed switchgear for rated voltages above 52 kV.52 kV及以上气体绝缘金属封闭开关设备的电缆连接IEC 60859(306)Direct connection between power transformers and gas-insulated metal-enclosed switchgear

9、 for rated voltages above 52 kV.52 kV及以上发电机变压器和气体绝缘金属封闭开关设备的直接连接IEC 61639(307Use of electronic and associated technologies in auxiliary equipment of switchgear and controlgear开关设备和控制设备的辅助设备种电气和相关技术的使用IEC 62063(308)Guide for asymmetrical short-circuit breaking test duty T 100a非对称短路开端试验导则-(309)TRV par

10、ameters for high-voltage switchgear and controlgear for rated voltages above l kV and less than 100 kV.-(310)Electrical endurance testing for circuit-breakers rated 72.5 kV and above72.5 kV及以上的断路器的电动力续性试验-62271-2003IEC:2003Table 102-Preferred rated insulation levels for rated voltages for equipment

11、of range 1Rated voltage for equipmentUrkV (r.m.s.value)设备额定电压Rated short-duration power-frequency withstand voltage（额定短时工频耐受电压）UdkV (r.m.s.value)Rated lightning impulse withstand voltage（额定雷电冲击耐受电压）UpkV(peckvalue)Phase-to-earth, across open switching device and between phase相对地，相间和通过断开的设备Across the

12、isolating distance通过的绝缘距离Phase-to-earth, across open switching device and between phase相对地，相间和通过断开的设备Across the isolating distance通过的绝缘距离(1)(2)(3)(4)(5)72.514016032537510018521045052012323026555063014527531565075017032537575086024546053010501200NOTE Values in column(2) are applicableA) For type test

13、s, phase-to-earth and between phases;B) For routine tests, phase-to-phase, and across the open switching device.Values in columns(3), (4) and (5) are applicable for type tests only.注意：第二列的电压用于：（1） 相对地和相间的测试类型（2） 第三、四、五列种的电压值仅适用于相对地，相间和通过断开的开关设备的常规测试，表类62271-2003IEC:2003Table 103-Preferred rated insu

14、lation levels for rated voltages for equipment of range IIRated voltage for equipmentUrkV (r.m.s.value)设备额定电压Rated short-duration power-frequency withstand voltage（额定短时工频耐受电压）UdkV (r.m.s.value)Rated switching impulse withstand voltage（额定开关冲击耐受电压）UskV (r.m.s.value)Rated lightning impulse withstand vo

15、ltage（额定雷电冲击耐受电压）UpkV(peckvalue)Phase-to-earth, and between phase (note 3)相对地和相间across open switching device and /or isolating distance(note 3)Phase-to-earth, and across open switching device相对地和相间between phase(note 4)相间Across isolating distance (note 1,2 and 3)通过绝缘距离Phase-to-earth, and between phas

16、e相对地和相间across open switching device and /or isolating distance(note 3)通过断开的开关设备和/或绝缘距离(1)(2)(3)(4)(5)(6)(7)(8)3004605958501275700(245)10501050(170)3625206759501425800(295)11751175(205)42065081510501575900(345)14251425(240)55071092511751760900(450)15501550(315)8009601270142524201100(650)21002100(453)

17、NOTE 1 column (6) is also applicable to some circuit-breakers, see IEC 62271-100.NOTE 2 in column (6) , values in brackets are the peck values of the power-frequency voltage Ur/2/ 3 applied to the opposite terminal (combined voltage)In column (8), value in brackets are the peck values of the power-f

18、requency voltage 0.7 Ur/2/ 3 applied to the opposite terminal (combined voltage).see annex D of IEC 60694.NOTE(3) Values in column(2) are applicable:(a) for type tests ,phase-to-earth and between phases;(b) for routine tests, phase-to-earth, phase-to-phase, and across the open switching device.Values in columns(3), (4), (5), (6), (7) and (8) are app