参考说明成果ha33-ca2509

1、Airlines Limited航空03110-01Airlines MEDAirlines LimitedWO NO/工作指令号SEQ NO/序列号培训方式MAOHKG25001613通用类/GenericTitleDetailed examination the lavatory partsMcd&Rev/厂家工卡&修订日期NONE标题厕所详细检查A/C/飞机号Subtask No/工JC Rev/工卡版本号Work area/工作区域Skill/工种Man Hour/工时Rev. 01RIM08:00BLNEHA33-CA-25-09-102客舱/CabMP Item/MP 号Basel

2、ine/依据MP REV/ MP 版本号Sion/维修站Threshold/首检erval/重复检-Rev. 011C1CAcs Panels/接近盖板Zones/区域Written/编写Approved/批准NONE2002015-03-232015-03-23TOOLS/工具TOOLS NESARY/必须工具ITEM项目P/N件号DESCRIPTION名称EQTP类型QTY数量APP适 用性Conditions note互换信息及备注TOOLS IF NESARY/视情工具ITEM项目P/N件号DESCRIPTION名称EQTP类型QTY数量APP适 用性Conditions note互换

3、信息及备注1ZBMS1TO1ALL毛刷-1 寸-brush(视情/As Nesary)2ZB237TO1ALL-500LM(视情/As Nesary)3ZGXCQ1TO1ALL(视情/As Nesary)吸尘器4MB-TYTO4ALL(视情/As Nesary)抹布PARTS AND MATERIAL/航材NOTE: OPERATOR MUST GET AND INSTALL THE PARTS注释：请工作者严格按照工作指令号领取预定的航材装机T CORRESPOND TO THE RELATIVE WORK ORDER NO.PARTS AND MATERIAL NESARY/必须航材ITE

4、M项目P/N件号DESCRIPTION名称EQTP类型QTY数量APP适 用性Conditions note互换信息及备注PARTS AND MATERIAL IF NESARY/视情航材ITEM项目P/N件号DESCRIPTION名称EQTP类型QTY数量APP适 用性Conditions note互换信息及备注IMPORTANT NOTE:he event of any discrepancies betn the Chi instruction and the English instruction, the English procedure should prevail.Record

5、 Additional Work/Findings(If Applicable) Reference No.of Release to Service(* Tick as appropriate# Different crews should perform the work on each of the systems)Certifiest the work specified, except as otherwise specified, was carried out in accordance with HKAR-145 and in respect tot work, The air

6、craft / aircraft components are considered ready for Release to Service.HKA Approval No: AI / 135 / 706 *HNAT Approval No.: JMM 049, D500023 *HAECO Approval No: DAI / 1 / 853 *HNAT Approval No.: JMM 076, D3039 *CASL Approval No: AI / 101 / 798 *SIAEC Approval No: AWI / 01 *HNAT Approval No.: JMM 047

7、, D101115*TAECO Approval No.: DAI / 89 / 1295 *STARCO Approval No.: JMM 039, D.200078 *SMECO Approval No: JMM 081, D.400009 * AMECO Approval No.: JMM001,D101131*Other: *Signature:_ _ _ _ _ _Authorization No.:_ _ _ _ _ _Date:_ _ _工卡Job card:TITLEDetailed examination the lavatory partsPerfInsp标题厕所详细检查

8、工作者检查者WARNING: PLEASE OBEY ALL WARNING AND CAUTION OF REFERENCE MANUAL, OTHERWISE IT SHOULD CAUSEAL INJURE OR DAMAGE TO EQUIPMENT.Job Set-upA：Energize the ground service network (Ref. AMM TASK 24-42-00-861-801)Get acs to the inspection area and parts.Disassemble the lavatory parts as far as nesary f

9、or a satisfactory visual inspection.Clean the lavatory parts before you start with the visual inspection.Optical instruments can be used to help the inspection.Make suret you have sufficient lighting for the inspection.ProcedureA. Visual Inspection of the LavatoryNOTE: Whenng visual inspections it i

10、s nesary to know thesible damages and incorrect conditions whiay show and the areas where these can occur.Always inspect the lavatory structure for:wear;mechanical damage ;corroandoxidation;heat damage ;other incorrect conditions .Make suret you can read all labels and markings NOTE：Check the placar

11、ds refer to the cabin placard specification.B：Visual Inspection of the Structure Panels and DoorsExamine the sandwich panels and the doors for deformation, cracks, dents, holes and delamination is or not.Replace damaged sandwich panels and doors.Theum edge length of damaged areas is 200 mm (7.874 in

12、) x 200 mm (7.874 in).Bond agahe delaminated decorative material.Examine the lower area of the lavatory wall for corro. Up to aum height of400 mm (15.748 in) you can repair the wall. If this area is higher change the wall.Examine the lower attaent fittings of the walls for corro, oxidation and damag

13、e.C. Visual Inspection of the Washbasin DoorExamine the washbasin door for cracks or damage is or not.Examine the washstand door and the latch for cracks or damage is or not.Examine the hinges of the washbasin panel for cracks or damage is or not.D. Visual Inspection and Check of the Folding Door De

14、r工卡Job card:TITLEDetailed examination the lavatory partsPerfInsp标题厕所详细检查工作者检查者Make suret the folding door is installed correctly and can be opened and closed easily.Compress the spring loaded bolt and make suret it operates correctly.WARNING: BE CAREFUL WHEN YOU USE MATERIAL NO. 04-012 PURE MINERAL

15、VASELINE OR PETRO-LATUM. OBEY THE MATERIAL MANUFACTURERS INSTRUCTIONS.Make sure the der is clean and quiet in operation. If nesary, lubricate with spray onVaseline Material No. 04-012, Pure Mineral Vaseline or Petro-Latum .E：Visual Inspection of the Water System(1) Make suret the brackets and suppor

16、ts are attached correctly and are not damagedor missing.(2).Make suret the hoses, the tubes, the fittings and the hose connections are attachedcorrectly and are not damaged, leaking or missing.Examine the hoses and the gaskets/O-rings for leaks and sign of deterioration is or not.F：Visual Inspection

17、 of the MirrorExamine the mirror for cracks, scratches and stains is or not.Operation check make sure the toilet mirror door unit open and close is normalThe lock unit work is normal ,the locks and lock hole no wear.Make sure the limit line no losse on the stowage door, and the bumper block function

18、normal when the door closing.Make sure no item prere the stowage door when closing mirror door.Make sure the lock switch function is normal on the mirror door.G：Visual Inspection of the Laminated Floor Pan(1).Make suret the laminated floor pan is not damaged.Examinet the laminated floor pan has no s

19、ign of wear or air pockets.Make sure no odor from laminated floor surface and seams(4) If nesary, replace the laminated floor pan.H：Visual Inspection and Check of the Toilet Seat and the Toilet CoverMake suret the toilet seat and the toilet cover open and close correctly.Examine the toilet seat and the toilet cover for cracks, scratches or stains is o