U-GLIDER优雷特滑翔机说明书

1、U-GLIDER优雷特滑翔机说明书公司地址：二路益众科技园A1栋4楼电 话：+86-传 真：+86-邮 编：523785ADD: 4/F,Building A1,Yizhong Science and technology park , Jinsha Road two,ShuiKou Villiage,Dalang Town,DongGuanTel: +86- Fax: +86-        所有零件All spare partsOp

2、en the Carton开箱图Install the steel wire放好钢丝Glue in the card slot在凹槽打胶All OverInstall the control horn on the wings所有舵角安装完成安装舵角Notice: Carbon tube must be pushed to the end of plastic parts, otherwise the length is not appropriate.此处注意碳杆一定要推到最前，否则长度不合适Carbon tube and plastic parts assembly将碳管与塑胶件装到一起压

3、入碳杆 Glue and install the plastic slice on the wings, pay attention to the plastic slice size.装舵机Install the ServosPush the carbon tube打胶安装机翼塑胶片注意塑胶片一大一小平尾钢丝插钢丝· Notice: After the installation, please glue the rubber tube and carbon tube to assure the efficiency of the servo此处注意为了保证舵效安装完飞机之后要将两头

4、胶管与碳管点胶水固定住Rudder steel wireElevator steel wire此处有孔The hole at here垂尾钢丝Insert the steel wire碳管外露长度541mm碳管从尾部插入，注意留出长度，长度见下一张图带折弯的一头one side of the curved steel wire碳管从飞机尾部插入，注意露出长度约为541mmInsert the carbon tube from the tail of the airplane, the show length should be about 541mmInsert the steel wire

5、to regulator of the elevator将钢丝插入升降舵上的调节器内Carbon tube alignedwith the foam corner此处注意碳杆与泡沫件拐角平齐Apply glue in the back of elevator平尾反面打胶打胶并安装垂尾Glue and install the rudder装摇臂Install the rocker 给木片插到此处，为了维修方便不用打胶!Insert the wood chip as displayed, dont need apply glue,easy maintenance下面是飞机涂装粘贴教程Flow ar

6、e sticker photos滑翔机配件表U-Glider Spare Parts List名称Item Name详情Description塑胶件Plastic parts机翼塑胶片*2/Plastic slice*2 on wings舵机固定塑胶件*2/Plastic parts*2 on servos碳管链接塑胶件*1/Plastic parts*1 on carbon tube舵机摇臂*3包/Rockers*3 on servos 舵机*1/Servo*1舵角、螺丝、扳手Control horn;Screw;Wrench舵角*4/Control horn*4信号线扎带*2/Cable

7、ribbon*2小金属调节器*5（其中一个备用）Metal regulator*5(one of them as a common spare)0.3内六角扳手*1/ 0.3 Hexagon wrench*13*30攻丝螺丝*1（固定机翼）3*30 self-tapping screw*1(fix wing)3*20攻丝螺丝*1（固定机翼）3*20 self-tapping screw*1(fix wing)碳管Carbon tube 3*3*54方管*2/3*3*54 square tube*2 3*3*68方管*2/3*3*68 square tube*2 6*6*80方管*1/6*6*80 square tube*1钢丝Steel wire副翼钢丝*2/Aileron steel wire*2升降钢丝*1/Elevator steel wire*1方向钢丝*1/Rudder steel wire*1发泡件Foam parts机翼*2/Wing*2平尾*1/Elevato