网络管理技师技能考试实验18：路由重分发(路由注入)讲诉

1、实验18:路由重分发（路由注入）參««曲畑）谄賀1工作：Ktribu* BAW0fiO?jfD/O1 號 1» 丨 1/24R0m. IM 3 1/L4£0/019f 1« 3 2/ ?4I9Z. 163.2 I/Z4在犬昱的左业中 > 町® ERFAftl5 *f«S*WiSt 衍了FtW俪曲旳谒的忡制工作 > 歸由那可I快用"1IW於ga待JT学习目庄-刑SlT加:晒曲:玫另一陀谢勺农广出去 遠1st 7 通了l%r 160 1 2/Z4话擀S由ttt? IBS 4 1/2410/016S.4 2/

2、24L«. L63 S. 1/240®1041RZ1« 01% IM S 1/24£0与Bl 磴过ti加老 12与RL 曲RL p 過!QlHklft议1 重分发 flJt&IP：(e«nfif)retil«r ripW： (cwfirreat«r)*r«4illribut tlalic nitric 2IIS (c«nfi c-Tflul<r?Uibflli rmftteltd scUie 12 BX>J0£fr(-£vik£ i. ()t mt

3、1;fc Citjif 1 F1F : (C4ef3C4Tit*rIVradaxtribut* 卫接；(ciitf? r-rout*r iwi iia itrvkut* 静环：C4ii.fi-r sut*r JI±«distribut*ri> Tubfitli < 3bftttT'*T¥FU ) gwccmL*e<ti玄私堇左RIFOSFF (cnfic-rfluter Ifrediilr ibite «spf 1 netric 3首先先配置RO跑np协议、R2 B9 opt瞬议、R3的静态路由协议，緩若配宣R1路由里的童分发协

4、认 此讨脸里RL充当这粧译的工柞R0Route r*enRocterWconf tRoute r(config )#host ROROfconfig)#roLiter ripR0( config - 脸1.0网段个2.0网段活加rip协议R2Router =-enRouterconf tRouter (config)* host R2R2(config)#routcr ospf 1R2(config - a 0R2：config router)#netwcrk a 0"给3 0网段和5 0网段潘加ospf协叹R3Router j-enRouter#conf IRoute r (con

5、fig )#host R3/默认的靜态路由（因为R3是適过4.1勺外界通危通往R3的静态路由协议/rip直连网络車分发/rip静态路由垂分发ULt步驟均为rip协议重分发R1RouteoenRouter#conf tRouter(config)#host R1Rl(config)#router ripRl(configuter冲redistribute connected metric 1Rl(configrouter)#redi$tribute static metric 2Rl(config-router)#AZR1 (config-router)#network 192.168.3.0

6、0.0.0.255 a 0 Rl(configrou2r)nredisulbiHe connected Rl(configrouter)伴redistribute staticRl(config outerj# redistribute rip sub netsR l(config - router)# A Z Rl#/ospf JSil协议更分发/ospf静态路由堇分发/ospf协议rip吏分发Ot步慕均为ospf协议重分发Rl#conf tRl(config)#router ripRl(configrouler)常redistribute ospf 1 metric 3/rip协议ospf

7、車分友R1#Rl#conf tRl(config)#router ospf 1Rl(config-router)#路由当作主机来pin?其他路由的ip地址知识扩展R3 徉 pingProtocol ip: ipRepeat count ：Datagram size |100):Timeout in seconds 2:Extended commands n: yType of service 0:Set DF bit in IP header? (no):Validate reply data? no:ip协议/默认默认默认扩载按Y/源地址默认/畑/默认Data pattern OxABCD:

8、/ 默认Loose, Strict, Record, Timestamp, Verbosenone: / 默认 Sweep range of sizes (n:/ 默认Type escape sequence to abort 默认iiiii Success rate is 100 percent (5/5), round-trip min/avg/max = 47/59/62 msRouter>enableRouter#configure terminalEnter configuration commands, one per line. End with CNTL/Z. Route

9、r(config)#interface FastEthernet0/0Router(config-if)#ip address Router(config-if)#no shutdownRouter(config-if)#%LINK-5-CHANGED: Interface FastEthernet0/0, changed state to up Router(config-if)#exitRouter(config)#interface FastEthernet0/1Router(config-if)#ip address Router(config-if)#no shutdown%LINK

10、-5-CHANGED: Interface FastEthernet0/1, changed state to up %LINEPROTO-5-UPDOWN: Line protocol on Interface FastEthernet0/1, changed state to up Router(config-if)#Router(config-if)#exitRouter(config)#interface FastEthernet0/0 Router(config-if)#Router(config-if)#exitRouter(config)#interface FastEthern

11、et0/1 Router(config-if)#%LINEPROTO-5-UPDOWN: Line protocol on Interface FastEthernet0/0, changed state to upRouter con0 is now availablePress RETURN to get started.Router>Router>Router>enRouter#conf terEnter configuration commands, one per line. End with CNTL/Z.Router(config)#Router(config)

12、#hosRouter(config)#hostna R0R0(config)#neR0(config)#rouR0(config)#router ripR0(config)#router ripR0(config-router)#neR0(config-router)#network R0(config-router)#network R0(config-router)#exiR0(config)#R0(config)#R0(config)#R0#%SYS-5-CONFIG_I: Configured from console by consoleRouter>enableRouter#

13、configure terminalEnter configuration commands, one per line. End with CNTL/Z.Router(config)#interface FastEthernet0/0Router(config-if)#no shutdown%LINK-5-CHANGED: Interface FastEthernet0/0, changed state to up %LINEPROTO-5-UPDOWN: Line protocol on Interface FastEthernet0/0, changed state to up Rout

14、er(config-if)#ip address Router(config-if)#Router(config-if)#exitRouter(config)#interface FastEthernet0/1Router(config-if)#no shutdown%LINK-5-CHANGED: Interface FastEthernet0/1, changed state to up %LINEPROTO-5-UPDOWN: Line protocol on Interface FastEthernet0/1, changed state to up Router(config-if)

15、#ip address Router(config-if)#exiRouter(config)#Router(config)#Router(config)#hoRouter(config)#hostname R2R2(config)#rouR2(config)#router osR2(config)#router ospf 1R2(config-router)#neR2(config-router)#network a 0R2(config-router)#network a 0R2(config-router)#Router>enableRouter#configure termina

16、lEnter configuration commands, one per line. End with CNTL/Z.Router(config)#interface Serial0/0/0Router(config-if)#%LINK-5-CHANGED: Interface Serial0/0/0, changed state to upno shutdown Router(config-if)#ip address Router(config-if)#clock rate 64000Router(config-if)# Router(config-if)#exitRouter(con

17、fig)#interface FastEthernet0/1 Router(config-if)#%LINEPROTO-5-UPDOWN: Line protocol on Interface Serial0/0/0, changed state to upno shutdown%LINK-5-CHANGED: Interface FastEthernet0/1, changed state to up %LINEPROTO-5-UPDOWN: Line protocol on Interface FastEthernet0/1, changed state to up Router(conf

18、ig-if)#ip address Router(config-if)#exiRouter(config)#Router(config)#Router# %SYS-5-CONFIG_I: Configured from console by consoleRouter#Router#conf terEnter configuration commands, one per line. End with CNTL/Z. Router(config)#Router(config)#hosRouter(config)#hostname R3R3(config)#ip rouR3(config)#ip

19、 route R3(config)#Router>enableRouter#configure terminalEnter configuration commands, one per line. End with CNTL/Z.Router(config)#interface FastEthernet0/0Router(config-if)#no shutdown%LINK-5-CHANGED: Interface FastEthernet0/0, changed state to up %LINEPROTO-5-UPDOWN: Line protocol on Interface

20、FastEthernet0/0, changed state to up Router(config-if)#ip address Router(config-if)#Router(config-if)#exitRouter(config)#interface FastEthernet0/1Router(config-if)#no shutdownRouter(config-if)#%LINK-5-CHANGED: Interface FastEthernet0/1, changed state to upip address Router(config-if)#Router(config-i

21、f)#exitRouter(config)#interface FastEthernet0/0Router(config-if)#Router(config-if)#exitRouter(config)#interface FastEthernet0/1Router(config-if)#ip address Router(config-if)#Router(config-if)#exitRouter(config)#interface Serial0/0/0Router(config-if)#ip address Router(config-if)#no shutdownRouter(con

22、fig-if)#clock rate 64000Router(config-if)#%LINK-5-CHANGED: Interface Serial0/0/0, changed state to up%LINEPROTO-5-UPDOWN: Line protocol on Interface Serial0/0/0, changed state to up %LINEPROTO-5-UPDOWN: Line protocol on Interface FastEthernet0/1, changed state to upRouter con0 is now availablePress

23、RETURN to get started.Router>Router>enRouter#conf terEnter configuration commands, one per line. End with CNTL/Z. Router(config)#Router(config)#Router(config)#host R1R1(config)#ip rouR1(config)#ip route R1# conf terEnter configuration commands, one per line. End with CNTL/Z.R1(config)#R1(confi

24、g)#R1(config)#ip rouR1(config)#ip route R1(config)#rouR1(config)#router ripR1(config-router)#neR1(config-router)#network R1(config-router)#reR1(config-router)#redistribute conR1(config-router)#redistribute connected meR1(config-router)#redistribute connected metric 1R1(config-router)#reR1(config-rou

25、ter)#redistribute stR1(config-router)#redistribute static meR1(config-router)#redistribute static metric 2R1(co nfig-router)#AZR1#%SYS-5-CONFIG_I: Configured from console by consoleR1#R1#R1#conf terEnter configuration commands, one per line. End with CNTL/Z.R1(config)#rouR1(config)#router osR1(confi

26、g)#router ospf 1R1(config-router)#neR1(config-router)#reR1(config-router)#redistribute conR1(config-router)#redistribute connected% Only classful networks will be redistributedR1(config-router)#R1(config-router)#reR1(config-router)#redistribute stR1(config-router)#redistribute static% Only classful

27、networks will be redistributedR1(config-router)#reR1(config-router)#redistribute riR1(config-router)#redistribute rip suR1(config-router)#redistribute rip subnets ?tag Set tag for routes redistributed into OSPF<cr>R1(config-router)#redistribute rip subnetsR1(config-router)#neR1(config-router)#

28、network arR1(config-router)#network area 0R1(config-router)#reR1(config-router)#redistribute ?connectedConnectedeigrpEnhanced Interior Gateway Routing Protocol (EIGRP)metricMetric for redistributed routesospfOpen Shortest Path First (OSPF)ripRouting Information Protocol (RIP)staticStatic routesR1(co

29、nfig-router)#redistribute conR1(config-router)#redistribute connected ?metric Metric for redistributed routesmetric-type OSPF/IS-IS exterior metric type for redistributed routes subnetsConsider subnets for redistribution into OSPFtag Set tag for routes redistributed into OSPF <cr>R1(config-router)#redistribute connected% Only classful networks will be redistributedR1(config-router)#reR1(config-router)#redistribute st R1(config-router)#redistribute static ?metric Metric for redistributed routesmetric-type OSPF/IS-IS exterior metric type for redistributed routes subnetsConsider subn