西子奥的斯FOVF[行业相关]

1、BEING THE BEST AT WHAT WE DO 1 FOVF Control System Introduction OH-CON4421 System XOEC 2006-3 BEING THE BEST AT WHAT WE DO 2 OH-CON4421: elevator use LCBII,AMCB2, SIEI drive and gear machine Meaning of controller name BEING THE BEST AT WHAT WE DO 3 System introduce BEING THE BEST AT WHAT WE DO 4 LCB

2、II BEING THE BEST AT WHAT WE DO 5 Setting of LCBII installation parameters of OH-CO N4421 system is similar to MCS220M system| LSVF-W drive model M1-3-1-4Drive: 17 if ADO, set to 16 Two sensors for DZ signal M1-3-1-6DZ-TYP: 1 The distance of two sensors is about 60mm, and the length of vane is 250mm

3、 LCBII Parameters Setting BEING THE BEST AT WHAT WE DO 6 LSVF_W: DS Codes DS1 DS2 DS3Remark 111Stop and drive ready 110Run speed Ent No-Esc STARTUP Save config？ 6. When finished the autotune, press key, the keypad wil l display: 7. Press the Enter key, then press the key twice 8. After finished the

4、autotune, press the Enter key to save the autotune parameters BEING THE BEST AT WHAT WE DO 13 AMCB2 interface board BEING THE BEST AT WHAT WE DO 14 AMCB2 BEING THE BEST AT WHAT WE DO 15 AMCB2 have 5 keys located below the display:, ,enter :back :shift P and F menu :add the parameters value :reduce t

5、he parameters value Enter：enter the F menu; conform the modification Keys of AMCB2 BEING THE BEST AT WHAT WE DO 16 Terminals of AMCB2 BEING THE BEST AT WHAT WE DO 17 Before the hoistway Self-study, you must conform th e following items： 1. Finished the motor autotune, conform all connect wire use fo

6、r autotune have removed the short wiring 2. Parameters of drive and AMCB2 have finished set ting 3. the elevator can run in inspection mode 4. Enter to the F menu of amcb2, and set the F24 to 0. the parameter only allow the elevator to inspect ion and learn run Hoistway Self-study BEING THE BEST AT

7、WHAT WE DO 18 Hoistway Self-study 5. switch the ERO to normal, set the parameter F0 of AMCB2 to 0, then press the Enter key to start 6. The car run down to bottom floor with low speed, then run up till the top floor to finish the hoistway Self-study 7. After hoistway self-study, the parameter F24 of AMCB2 will set to 1 automatically 8. You can get the self-study parameter form AMCB 2: P1P32: floor distance P34P35:1L