RFID车辆电子标签法规

1、Radio Frequency Identification (RFID)lRequirements: GB7258-xxxx/ 11.9 Installation of Electronic Registration Identification (ERI)A window for microwave should be set on the front screen of the vehicle where theres no impact on the vision of driver in order to comply with the request of electronic r

2、egistration identification data reading in ; the installation of ERI should fulfill . 7 month of transitional period for NT vehicleIllustration of RFID read-write systemlSpecifications of ERI:GBTXXXX-XXXX General Technical Specification of Electronic Registration Identification of Motor Vehicles/ A.

3、2 Dimensions ERI of motor vehicles shall comply with the requirements for the limits of length, width, height and fillet radius shown in below Figure. Left boundaryUpper boundary Unit: mma (length)b (width)c (fillet radius)d (thickness)Max. Min.Max.Min. Max. Min. Max. Min. Dimension86.5 85.5 54.5 53

4、.5 3.63.4 2.62.4Encapsulation structure lInstallation:Location of ERIFor vehicles on which the installation position has sun-shield film, remove the sun-shield film at the installation positionRequirements for adhesive a) Adhesive shall assure that no fall-off would occur within 10 years; b) After t

5、he use of 10 years, the transparency shall be no less than 80% of the original value; c) The thickness of adhesive shall be no less than 0.5 mm; d) The glass adhering area shall be no less than 50% of the ERI area; e) The adhesion strength shall reach 0.28 N/mm; and f) It shall comply with the envir

6、onmental protection requirements. lImpact on Vehicles: Safety glass: specific metal materials added? Possible to remove a part of the sun-shield film?Already too many devices around the vertical center axis of windscreen: CDPL, IDVR, upper mirror foot, CVM etc. you can find out one example layout as below (IDVR is not well located yet due to no place): l