《机电工程专业英语》A卷

1、号学名姓生学级班业专线 订 装 此 过 要 不 题四川理工学院成人高等教育机电工程专业英语试卷(A卷)年级三年级 专业机电一体化 Z机31101层次 专 科题号一一二四五八七八总分评阅(统分)人题分20302030得分注意事项：1.满分100分。要求卷面整洁、字迹工整、无错别字。2.考生必须将“学生姓名”和“学号”完整、准确、清楚地填写在试卷规定的地方，否则视为废卷。3.考生必须在签到表上签到，否则若出现遗漏，后果自负。一、选择题:得分评阅教师选择括号中提供的单词或短语，并以正确的形式填空。(每空2分，共20分)>班属在点学教(send out, focus on, deny, prov

2、e, make sure, equip with, shock, accomplish, vary from, call )(1) A week ago he received a notice stating his application was. (2) Effective teaching is the learning needs of each student in the class.(3) His mother when she heard about the accident.(4) He a number of e-mail messages to his friends.

3、(5) Position measurement in NC machinescan through direct or indirect methods.(6) The actual programming commands needed willalso builder to builder. This method to be very successful.机电工程专业英语试卷(A卷) 第1页(共4页)(8) thatthe instructions for the use of thisare strictly observed.(9) The majority of NC/CNCm

4、achine toolsautomaticsuch as magazines on machining center and turrets on turning centers.(10) The movements are detected and counted by a feedback device transducer.二、名词解释：写出下列英文缩写的全称(1) PLC(2) CIM(3) AGV(4) FMS ROM(6) CPUCNC(8) CAD(9) GUI(10) JIT三、汉译英：将下列术语翻译成英文。(1)在线编程(2)装配有(某设备)(3)钻床(4) 齿轮加工(5)穿

5、孔纸带(6)切削中心(7) 加工中心(8) 光电开关(9) 显示面板(10) 超声波加工四、英译汉得分评阅教师，并翻译成中文。(每题3分，共30分)得分评阅教师(每题2分，共20分)得分评阅教师机电工程专业英语试卷(A卷) 第2页(共4页)high pressure cooker tool changers, a把下列两段英文翻译成中文(每题 15分，共30分)(1) The important mechanical properties affecting the selection of a material are:(i) Tensile Strength(ii) Hardness(ii

6、i) Ductility(iv) Impact Strength号学(v) Wear Resistance(vi) Corrosion Resistance(vii) Density名姓生学级班业专订装 此过 要 不 题(2) CAD is a computer system which creates and displays graphic information on a cathode-ray-tube screen. It allows the designer to produce engineering drawings and modify them on the screen. CAD produces a picture on the CRT screen from electronic signals from a computer. The operator can use CAD system to produce a proper scaled drawing of the part on the CRTscreen and record it in the computer memory. If the design is correct, the plotter can be